Softstart Circuit for DIY Amplifiers

The softstart circuit is important for every DIY audio amplifier project. This circuit protects the amplifier from the initial high current surge when it turns ON. If you are building a large amplifier with a big transformer, the inrush current is also high. The high inrush current will damage the speaker and electronic components too.

Use of Softstart Board for Amplifier

  • Reduces high startup current by Limits the sudden current surge when the amplifier is switched ON.
  • Helps to protect the transformer, power supply and other components from electrical stress.
  • Reduces the chance of the AC fuse blowing due to high inrush current.

24V Relay Softstart Circuit Diagram

Softstart circuit for DIY Amplifier
Figure 1: 24V Relay softstart circuit for DIY Amplifier.

The circuit is designed with a small number of electronic components. The power supply to drive the 24V relay is through the transformerless power supply using 1uf/450v polyester film capacitor. The four 10 ohms 5 watt resistors provides the low initial startup current and protect from sudden surge of AC current to amplifier transformer.

Also Check: IC based soft start circuit without relay

List of Components Required

Sl. No.ComponentValue / SpecificationQuantity
1R11Mฮฉ / 1W1
2R2, R3, R4, R510ฮฉ / 5W4
3R6220ฮฉ / 1W1
4R74.7kฮฉ1
5U11ยตF / 450V Capacitor1
6C12200ยตF / 35V Electrolytic Capacitor1
7D2, D3, D4, D51N4007 Diode4
8DZ124V Zener Diode1
9K124V Relay1
10LED1LED Indicator1
11FUSEAC Fuse1
12J1, J2AC Input Connectors2
13J3, J4AC Output Connectors2
Table 1: Components list

Important: The circuit works at 230 V AC, so never touch the circuit while it is connected to the AC supply. Testing and installation require technical knowledge and proper care.

Working Principle

The working is easy to understand. When the amplifier is switched on, the AC voltage enters into the fuse and power is passes through the 10 ohms 5 watts resistors which connected in series with the transformer connection. The resistors limit the initial sudden inrush current and allow the transformer to start safely.

softstart circuit working
Figure 2: Softstart circuit working block diagram

At the same time, the 1N4007, 1uf capacitor, and 1 Mฮฉ resistor arranged as a bridge rectifier convert AC into DC. The 24V Zener diode stabilizes the output voltage and turns on the relay when the required voltage is reached. When the relay turns on, the high AC voltage reaches the transformer, and the amplifier starts to work normally.

Conclusion

This softstart circuit is a useful addition to any DIY power amplifier because it helps to reduce the sudden inrush of current to the amplifier boards when it turns on. The 10 ohms resistor limits the initial current flow and 24v relay activates after some milliseconds and provide enough current for operation.